|
|
|||||||
| Microstudio Help Post Microstudio questions, tips and suggestions here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
November 20th, 2005, 03:23 PM
|
|||
|
|||
|
Re-install Didn't Do It
I HAVE APLEXTOR 12/10/32A AND A PLEXTOR PX708UF BURNERS. IN THE MIDDLE OF DUPLICATING SOME DISC, SOMETHING WENT WRONG AND I GOT AN ERROR MESSAGE - -LOAD DISC COMMAND FAILED ON 2:1:0 device contains no disc or is not reading. (04h 00h 02h 02h 57h 00h). I UNINSTALLED THE DRIVER, UNINSTALLED MICROSTUDIO, REINSTALLED MICROSTUDIO, BUT HAVEN'T BEEN ABLE TO REINSTALL THE DRIVER. I GET AN ERROR MESSAGE THAT SAYS IT WAS UNABLE TO INSTALL THE DRIVER.
THE PROGRAM OPENS VERY SLOW - WHEN I CAN GET IT TO OPEN AT ALL.
__________________
sham823 
|
|
#2
November 21st, 2005, 02:44 PM
|
|||
|
|||
|
When you say Driver are you referring to the ASPI driver? There is no other driver than this, that I know of, as everything is Built into the Microstudio.exe file.
You should also update the firmware for your Plextor drives to see if this will help from: http://www.plextor.com/english/suppo...oads.html#firm
__________________
Bryan, MTU
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
