step by step Instructions

[Shestepsin]

Confused here Please help
I need step by step instruction or hand holding
i have a large number of karaoke cd's
I would like to down size when I go out for example
put 1 or 2 tracks off a few cd's and make it into one cd
or even just 1 single track and put on a cd by itself
300 cd's are too much to carry
but when i look at the program the only light i see is one that says Duh your blonde lol could you send me something simple please Thanks

[admin]

1. Run Microstudio.

2. Click the Help menu and the Read Manual... command.

3. The Manual will appear in your Browser. If this does not display the Manual, run Internet Explorer (your Microsoft Browser), then click the Browse button and go to C drive: Program Files: Micro Technology Unlimited: Microstudio: :Manual and open the mstudioman.htm page.

4. Read about the Import Tracks Tab to import your single songs. Make sure you have the CDG button pressed to import Karaoke CDG songs.

5. Read about the Custom Assembly Tab to assemble your single songs into a new Assembly List to write to the CD Recorder. Make sure you have the Karaoke CD+G button pressed to assemble and write a CDG disc with CDG songs.

If this does not solve your problem, post back here where you succeeded in getting to and then got lost. We can't do much more than guide you. All the instructions you need are in the Manual.

[Shestepsin]

Great that helps to know what section to read again.
I did and it works great!!!!! thank you
But I have 1 more question If you have the time
It recorded just fine but i was told to record @ 1x mine recorded @ 6x which section do I read again to change this or does it matter? since it came out good. Thank again terri

[MTUSUPPORT]

Terri,
I would run the drive as fast as you can to limit time issues. We always recommend depending on your recorder to go as fast as it can. With the Plextor brand of drives you can write at the full 40 or 48x speeds with no problems. You can change this by clicking the Drives Menu, Speed Seelection. This is where you can change the speeds to whatever you would like. I always recommend for everyone to set the Read and Write both to Auto. This will allow the drive to go as fast as it can.