|
|
|||||||
| Hoster Help Post Hoster questions, tips and suggestions here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 26th, 2009, 04:22 PM
|
|||
|
|||
|
As long as you have had 4.06 installed on it you should be able to load it without a problem (registration wise) after they reset it. I say should but you may have to install 4.06 first then upgrade. Try it and see after they reset it.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
|
#2
September 26th, 2009, 07:42 PM
|
|||
|
|||
|
I just found out that related to the problem of registration, I cannot open Microstudio(v4.06) and Songverter(v1.21) now , too. The message says that the "Your serial number does not match your registration information. Please
reinstall Microstudio and try again, Same with Songverter. I thought MTU already fix this problem before and in fact they ask me to use one email address only which I did.
|
|
#4
September 30th, 2009, 10:39 PM
|
|||
|
|||
|
Tried to install Hoster v4.06a first before v4.10 (yesterday and today) but i'm still getting the same message that my "registration code was found disabled".
So, i'm still here hopeless with this problematic program. Any advice... I send another ticket for the same problem and i have no choice but to wait again...
|
|
#5
September 30th, 2009, 10:54 PM
|
|||
|
|||
|
Yes you will have to wait until they reset it. What that message means is you have installed Hoster as many times as they allow without a reset.
As far as the problem with the other message about being the wrong registration they did fix it but pert of the fix is you have to run regedit to delete some information. I'll have to research exactly what needs to be deleted to stop this from happening again.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
|
#6
October 1st, 2009, 10:35 AM
|
|||
|
|||
|
I only install Hoster when they reply to my ticket that I can install it. Just following what is instructed. and also, follow your instruction to get all the updates (auto/custom) and run advanced system care. My computer seems to be ready for the install. It's just that on the portion where you send my info to mTU, The message showed up that the install will not proceed. Please advised also that my Show computer (v4.09d) is also waiting to be upgraded to V4.10 but i'll hold it for awhile. I'll settle this one first..
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
