upgrde gone bad!!!

[djmadmaxx]

Gpayne, it has to be something on YOUR end.. The skip feature works fine on my PC's with 3.311

[gpayne]

Originally Posted by djmadmaxx

Gpayne, it has to be something on YOUR end.. The skip feature works fine on my PC's with 3.311

That could be so but if it is, the same thing is wrong with Aarrgee's machine. I did not even do the install until after I read his post. When I did do the install, I had the same problem he did. Go figure. This is my backup machine and as such, I have a lot of programs installed on it. When I get a chance, I will set a restore point and do an install on my show machine. Are you sure you elected to skip a playing song in auto mode?

gpayne

[ddouglass]

Originally Posted by gpayne

That could be so but if it is, the same thing is wrong with Aarrgee's machine. I did not even do the install until after I read his post. When I did do the install, I had the same problem he did. Go figure. This is my backup machine and as such, I have a lot of programs installed on it. When I get a chance, I will set a restore point and do an install on my show machine. Are you sure you elected to skip a playing song in auto mode?

gpayne

MikeP came up with this one.
Switch back and forth from Auto to Manual checking the skip each time. At some point it should begin to work. At that point exit Hoster and re-open. Skip should be still working from then on. It worked for me.

[gpayne]

Originally Posted by ddouglass

MikeP came up with this one.
Switch back and forth from Auto to Manual checking the skip each time. At some point it should begin to work. At that point exit Hoster and re-open. Skip should be still working from then on. It worked for me.

This procedure worked for MikeP? So, MikeP had this problem also? I wonder how many people had this problem? It sounds as if something is not getting set properly when you select skip and by going back and forth between manual & auto modes it gets set properly. I can try this and see if it works, but I'd also like to know why it works and if this is just something not working properly on my machine or not. It seems some are having the problem and some are not. I know from past experience that a fresh install of the operating system can cure a lot of problems but believe me, I have too much other stuff on my backup machine to reinstall everything. That will be a last resort. (dire!!!!!) Most of the bugs that have been fixed in version 3.111 were no problem for me because I did not import in that manner so if I have to I will stick to the last version that worked well for me!

gpayne

[ddouglass]

I agree something isn't getting set initially and it may be a hold-over from previous setups. I had never used the auto/skip and wasn't even aware of it until it was posted here.

Even though you haven't run in to the bugs that are fixed in this version it is still a good idea to upgrade anyway to keep up with the code changes and keep your registration good. We don't know how often upgrades will come out and delaying might cost if you go past a year.