![]() |
|
Vogone Help Post Vogone questions, tips and suggestions here. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: About to scream
Ok I got some songs to work really well and I got he timing down and i converted it to CDG and I saved it to a disk and imported that disk and ID to hoster.. but now when they play in hoster the timing is way off. I was right in KHP but then in hoster im like 2.0 seconds off and the playback offset doesnt help at all....NOW WHAT?? LOL
__________________
www.myspace.com/drkaraoke |
#2
|
|||
|
|||
Re: About to scream
Strange that the playback offset won't compensate.
Let's try adjusting your audio hardware accelerator. Click START. Click RUN. Type in DXDIAG. Click OK. After everything opens up at the top of the page open SOUND 1 In the power left hand side of the page there's a slider next to HARDWARE SOUND ACCELERATOR LEVEL. Move the slider one notch to the left. Click SAVE ALL INFORMATION, close out, open Hoster, and see if there's any improvement, even using the PLAYBACK OFFSET. If no change, repeat the process one notch at a time, as many times as necessary. If no change after moving the slider fully to the left,, put it back to one notch from the right and leave it there. That setting usually is optimum. If that doesn't get it, then move over and make room for me up in that tree with you, 'cause I don't have another clue at the moment.. ![]() George |
#3
|
|||
|
|||
Re: About to scream
could it be some setting in the KHP as I am setting the songs timming?
Also by to the left you mean less acc? Right?
__________________
www.myspace.com/drkaraoke |
#4
|
|||
|
|||
Re: About to scream
Correct, to the left is less accelleration. Most tkimes the default is wide open to the right, but sometimes that causes an out of sync situation with lyrics.
I can't think of anything in KHP since the finished track plays correctly when played back in KHP. George |
#5
|
|||
|
|||
Re: About to scream
I think you are running into the 16 bit problem. What you must do is open your Display settings, and change the colors to 16bit instead of 24bit or 32bit.
You do this by Right clicking on the Desktop, where there is no Icon, then left click the Properties button. Left click the Settings Tab, then change the colors on this tab to 16 bit. Now try Exporting the file again and see what happens.
__________________
Bryan, MTU |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|