![]() |
|
Singers & Hosts Wisdom Post how to be a great karaoke singer or host. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Re: Cut Out The Noise
I just solved a Dell Laptop's Hum w/ a 3 prong to 2 prong 'Ground-Lift' adapter.
I use an 1/8 Stereo to XLR (M) w/ Shielded Cable to solve my HP Laptop's Hum. This Shielded Cable has solved 3 x 'Desktop/Tower' PC's Hum problems. Just encountered an Equilizer that picked up a radio station (90.1Mhz) -- The EQ had both XLR and 1/4" Inputs -- I was using the XLR -- but ended up adding the 1/4" to it (nothing attached to the other end) and the Radio Station was gone! (I even attempted the Ground Lift) -- Their Engineer (Peavey) suggested that as a solution. And of course the old standard -- 'Dirty-Power' problem - reducing the 8K of the EQ will help -- but the Freqency's that you lose are detrimental to your sound quality. Agree w/ jdavia -- Isolating your problem hum is 1st priority - and the hardest as well! |
#2
|
|||
|
|||
Re: Cut Out The Noise
How would Y'all handel "hiss"?
I got some, but not much, It's just enough for the folks with "Good ears" to mention.
__________________
"Wild" Bill's Entertainment (910)-298-3927 |
#3
|
|||
|
|||
Re: Cut Out The Noise
Quote:
On the other hand the hiss could be from the way the amp was designed. I can't think of any other way hiss can be caused, except by a weak signal or poor recording. |
#4
|
|||
|
|||
Resolved
Don't know if the ground loopback and hiss problems have been resolved but here's some advice just in case..
Ground loop: Run all your equipment into the same power source. I use a power conditioner. IF the supply is wired properly and to a good ground, you shouldn't have a loop problem. In the case of an open ground, I have had to ground lift my Dell laptop as well. Not the best choice. As for hiss, it is usually a sign of too much gain on a noisey effects processor. turn off the effects and see if the problem goes away. If it does, then adjust accordingly for a happy medium. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|