Can't duplicate more than two CD+G's, before Lock-up

[jdavia]

If I duplicate two disc's, and copy the third disc to the hard drive, when it is nearly finished I get an error message saying:
"This program has performed an illegal operation and will be shut down.
If the problem persisist, contact the program manager.


DETAILS
MICROSTUDIO caused an invalid page fault in
module KERNEL32.DLL at 0167:bff88396.

And it freezes the program and computer, so I have to shut down (illegally too)
My common sense tells me that even though the previous data has been removed from my hard disc from the previous CD recordings, some memory or resources might be low. Imediately after I reboot, I can duplicate two more disc's as before. Any solution?

Win96SE version 4.10.2222A
128 OMB RAM
Physical Mem. 130,588 KB
System Resources 88%free
Free space 15.7GB
Upgraded to all the MTU drivers as directed
Microstudio Version 2.400
Pixelwriter 48/24/48U

I am duplicating some disc's now. It works perfectly for the first two, then I must shut down and re-boot to do more.
I know I can update to Win 2000 and maybe solve it. But afraid I might end up with other problems. Maybe one last fix with my same OS would be all I need.

Thanks

[BETAMAX-UK]

Go for win2000 i use it on my partition with xp both work great never did like 98se or me

[admin]

What version of Microstudio are you running? This was a problem in a past version that should not exist today in our current 2.400 version.

[jdavia]

Originally posted by admin
What version of Microstudio are you running? This was a problem in a past version that should not exist today in our current 2.400 version.

I gave all the particulars in my post. I am running the latest
version of Microstudio 2.400.
That is what the disc says. It better be because I just purchased the disc fron MTU 2/17/2003\.

[MTUSUPPORT]

Do solution #2 in this post to fix this problem: http://forum.mtu.com/showthread.php?threadid=493

[jdavia]

Originally posted by MTUSUPPORT
Do solution #2 in this post to fix this problem: http://forum.mtu.com/showthread.php?threadid=493

I upgraded to XP. Had to load Microstudio again, no more Error messages.
Thanks to all.