|
|
|||||||
| CD-Recorders and Media Open Forum All about drives and media |
 |
|
|
Thread Tools | Display Modes |
|
#1
January 11th, 2003, 08:46 PM
|
|||
|
|||
Microstudio locks up in custom assembly
When using Microstudio 2400 (custom assembly), I can import from c: drive, but when I go to write to cd computer locks up, then I have to use reset button to re-boot computer. I have a AMD athlon T-Bird 128 meg ram 800 mhz. I have been able to make custom CDG's, so I was wondering If I have a conflict somewhere?
 
|
|
#2
February 3rd, 2003, 11:36 AM
|
|||
|
|||
Computer Lockup when using custom assembly
After testing my equipment I have found that my Yamaha Drive Is not compatible for writing CD+Gs It was also creating problems with all MTU software. I replaced my drive with a Plextor 40x12x40 and have Eliminated All Problems. All Programs and drives are working Great!!!
Yamaha (not good) PLextor (GREAT)
|
|
#3
February 4th, 2003, 10:35 AM
|
|||
|
|||
|
Glad this fixed the problem.
__________________
Bryan, MTU
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
