Microstudio locks up in custom assembly
When using Microstudio 2400 (custom assembly), I can import from c: drive, but when I go to write to cd computer locks up, then I have to use reset button to re-boot computer. I have a AMD athlon T-Bird 128 meg ram 800 mhz. I have been able to make custom CDG's, so I was wondering If I have a conflict somewhere?:f
|
Computer Lockup when using custom assembly
After testing my equipment I have found that my Yamaha Drive Is not compatible for writing CD+Gs It was also creating problems with all MTU software. I replaced my drive with a Plextor 40x12x40 and have Eliminated All Problems. All Programs and drives are working Great!!!
Yamaha (not good) PLextor (GREAT) |
Glad this fixed the problem.
|
All times are GMT -4. The time now is 06:41 PM. |
Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2024, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.