Microstudio application has stopped working

[zilda]

i have removed totally the microstudio programme and deleated the download and re downloaded the version 4.23 all programmes within micostudio prog open ok ie Vogoen / keyrite / KhPro / Songverter and work. however if i try to open write disc the programme locks up instantly and the only option is to close it. i have tested the drive and it tests ok. however i tried the latest version on my lap top wich is vista and it works fine. but not ok on windows 7 64 bit. i have remove nero and another cd+g writing softwear to no avail.
many thanks zilda

[ddouglass]

You didn't need to remove Nero. I just needed to know if it was installed then you would need to make a minor change to its set-up.

In Microstudio did you select the drive(s) for both Read and Write? This is done in Tools/Default Drives.

[zilda]

i still have the nero software however it is not installed and yes i have tested packard bell cd rom and external plextor writers and both test ok i think

thw window shows Drive Label - E:\HL-DT-STDVDRAM GH41N MN01 / status Good but at the end of the line theres a button with bad on it also
M:\PLEXTOR CD-R PX-W4012A 1.00 status Good but at the end of the line theres a button with bad on it

[ddouglass]

The button at the end is for you to change the status of the drive manually. If you know the drive doesn't read CDG even though it tests good, then you can block that drive from being counted.
Did you also assign a drive for Read and a drive for Write (these can be the same drive) in the bottom part of that dialog box?
Have you tried with each drive assigned for Write function?

[zilda]

yes and it still locks up

[ddouglass]

Zilda, I don't know what else to tell you. I suggest you submit a Support Email Ticket from the Support section of the main MTU web page and let them see if they can figure it out.