|
Microstudio Help Post Microstudio questions, tips and suggestions here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Program wil not start - error messages
I lost my hard drive. Installed Windows 98-SE. Installed all of the Windows updates. Then installed Microstudio plus the Plextor USB driver and the file from Microsoft but that doesn't matter here.
Microstudio does not recognize the drive and Windows Explorer does not show it either. It was connected at the time the computer was turned on. Note that I am using USB 1.0. The connector was plugged into the USB 2.0 port on the Plextor before and it worked just fine. But it doesn't work now. Did I miss doing something? |
#2
|
|||
|
|||
Re: Program wil not start - error messages
Additional info. I just checked "system" in the control panel and it says the USB storage adaptor (Plextor) driver is not installed. It IS installed and when I tried to install it again it said it was already installed.
|
#3
|
|||
|
|||
Re: Program wil not start - error messages
Finally resolved issue on my own after working on it a lot more. Finally can record disks after two days of not being able to.
|
#4
|
|||
|
|||
Re: Program wil not start - error messages
I would say that it most likely is that you need to Install the latest Chipset drivers for your Computers Motherboard. This should have fixed it for you.
__________________
Bryan, MTU |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|