MTU.Community


Go Back   MTU.Community > Vogone & Vogone Easy Software > Vogone Help

Vogone Help Post Vogone questions, tips and suggestions here.

Reply
 
Thread Tools Display Modes
  #1  
Old August 25th, 2008, 03:23 PM
Kuurus Kuurus is offline
Registered User
 
Join Date: Jun 2008
Posts: 43
What do you folks use to pull CD tracks?

I seem to always have problems getting the vocals completely removed. No doubt its my inexperience with this particular product.

I have read that you need a .wav file recorded at 44.1 khz. What do you folks use to get a CD track over to a .wav file? I have a piece of shareware called mp3converter but wondering if there is something better. For instance if I start with a high-quality wma file and convert that to wav will that do the trick?

Incidentally, I have tried removing vocals from several CD tracks but I never have luck (ie I never have that "perfect" recording with no vocals). So I'd like to know what you folks use. I am generally pulling Pop/Rock 1980-90's with cneter-panned vocals. These typically have a lot of reverb as well. I have gotten to the point where I am left with reverb decay that I just can't get rid of....not enough tweakage left on the slider.

Thanks in advance.
Reply With Quote
  #2  
Old August 25th, 2008, 04:12 PM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
Best way I know of to get file to wav format is to set WMP to rip the song to that format.
As for reverb that is the biggest problem with trying to get the vocals out. I have never had any luck with it either. About the best you can do when reverb is there is get the vocals down to as low as you can.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
  #3  
Old August 25th, 2008, 06:01 PM
Kuurus Kuurus is offline
Registered User
 
Join Date: Jun 2008
Posts: 43
Thanks. So when using WMP to rip do you use "Lossless" mode? And also on the bit rate, if I select lossless, its 1411.2 Kbps. Will that work ok for Vogone? The guide says it must be 44,100Hz but I dont know how to get that if I let WMP rip to wav format.
Reply With Quote
  #4  
Old August 25th, 2008, 09:21 PM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
Should be able to change the bit rate too. I'll have to see if I can find it.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
  #5  
Old August 25th, 2008, 09:30 PM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
That is the ripping bit rate (how fast it rips) not the bit rate of the music itself. They should be right. Try one and see, bt if I remember the last time I did one that is how I imported the music.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
  #6  
Old August 26th, 2008, 06:19 PM
Kuurus Kuurus is offline
Registered User
 
Join Date: Jun 2008
Posts: 43
Quote:
Originally Posted by ddouglass View Post
That is the ripping bit rate (how fast it rips) not the bit rate of the music itself. They should be right. Try one and see, bt if I remember the last time I did one that is how I imported the music.
So I guess my dumb question is...how do I verify that the bit rate of the wav file is what I need? Does that show up in properties on the summary tab. I am guessing the "Audio Sample Rate".

Last edited by Kuurus; August 26th, 2008 at 06:27 PM.
Reply With Quote
  #7  
Old August 26th, 2008, 06:51 PM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
Yes and that is what needs to be 44KHz. It really depends on the rate that the music was converted from analog to digital originally. That is the audio sample rate.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
  #8  
Old October 3rd, 2008, 07:33 PM
mindonstrike mindonstrike is offline
VIP
 
Join Date: Mar 2001
Location: Spokane Wa/Post Falls Id
Posts: 2,656
Quote:
Originally Posted by Kuurus View Post
I seem to always have problems getting the vocals completely removed. No doubt its my inexperience with this particular product.

I have read that you need a .wav file recorded at 44.1 khz. What do you folks use to get a CD track over to a .wav file? I have a piece of shareware called mp3converter but wondering if there is something better. For instance if I start with a high-quality wma file and convert that to wav will that do the trick?

Incidentally, I have tried removing vocals from several CD tracks but I never have luck (ie I never have that "perfect" recording with no vocals). So I'd like to know what you folks use. I am generally pulling Pop/Rock 1980-90's with cneter-panned vocals. These typically have a lot of reverb as well. I have gotten to the point where I am left with reverb decay that I just can't get rid of....not enough tweakage left on the slider.

Thanks in advance.
To the best of my knowledge reverb is nearly impossible to get tid of. The whole idea of reverb is to make it sound like it's in different kinds of rooms, which means hearing reflections off of different walls. To get this illusion the reverb cannot be center panned, It does a lot of bouncing from one side to the other.
Reply With Quote
  #9  
Old October 21st, 2008, 05:51 PM
billyo billyo is offline
Registered User
 
Join Date: Jan 2005
Location: Las Vegas, NV
Posts: 2,202
years ago when i started to used cdg's a friend of mine who was in japan at that time sent me a cdg player, and this one was able to removed vocals i think it was called "samurai" i think it was made by aiwa..and this one could removed vocals from a regular ( red cd's )...i ended up trading it with a tapco ( which is now a mackie ) mixing board.. when i started to used laptops..
Reply With Quote
  #10  
Old October 21st, 2008, 08:24 PM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
Billy the discussion is about permanently removing vocals from CD tracks not CDG tracks.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
  #11  
Old October 21st, 2008, 10:08 PM
mindonstrike mindonstrike is offline
VIP
 
Join Date: Mar 2001
Location: Spokane Wa/Post Falls Id
Posts: 2,656
Quote:
Originally Posted by billyo View Post
years ago when i started to used cdg's a friend of mine who was in japan at that time sent me a cdg player, and this one was able to removed vocals i think it was called "samurai" i think it was made by aiwa..and this one could removed vocals from a regular ( red cd's )...i ended up trading it with a tapco ( which is now a mackie ) mixing board.. when i started to used laptops..
I have a Panasonic 525 (525 - I think) that does a decent job of removing vocals. Back when I used it at shows there was a time or two I used that feature for singers who wanted to use their personal CD. As I recall it just removed the center panned audio, no other tweaking was available like it would be with Vogone.

Sam
Reply With Quote
  #12  
Old October 21st, 2008, 11:55 PM
billyo billyo is offline
Registered User
 
Join Date: Jan 2005
Location: Las Vegas, NV
Posts: 2,202
Quote:
Originally Posted by ddouglass View Post
Billy the discussion is about permanently removing vocals from CD tracks not CDG tracks.

i understand, i was just saying that i had a cdg player that can removed the vocals on a regular cd's ( we call regular cd's " red cd's ) and the friend that sent me that player is a musician and was playing in japan at that time and he use to used one of those to get the vocals out and he plays over the tracks....( sings and plays keyboards/piano & guitar )
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


All times are GMT -4. The time now is 01:21 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2024, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.