Kim, which version of Windows are you using?
You must install your pyrodrive kit software first. After that you must see how your kit is set up(drive mode)Optical or Hard drive. Set it for Optical. Go to control panel / system / device manager / cd rom see if it is listed with your other cd rom's
if not, you don't have it installed right. Check the simple info that comes with the drive about how to install it before you try to use it to do CDG. See if you can load the ADS software. When starting the drive.....You have to turn the drive on first(wait ten seconds) before you plug in the fire wire cable then it will show up. If you put the cable in first before you turn it on.....it wont work........and it could burn out the kit in the back of the box. I have 2 of these and have burned one out so I have experience with it.
September 17th, 2001, 11:43 PM
Pyro Kit Software
Hybrid Mode
