View Single Post
  #1  
Old February 12th, 2001, 10:46 AM
W. Wheatley W. Wheatley is offline
Registered User
 
Join Date: Feb 2001
Posts: 1
OK, so I\'ve taken a sample of noise- a nasty \'hum\' caused by bad mic. hookup- and I make a template, which I want to apply to an entire file. I\'ve gotten that far. The file recording is speech only- a lecture- the \'hum\' is very loud- probably 1/2 as loud as the speakers voice.
Please give me some hints as to hoe I could set this up, with specific settings for all parameters. I\'m a bit of a novice at this, and even though I\'ve read thru the 15 page Introductory Guide, I\'m getting horrible results, which I know are only due to the fact that I don\'t know what I\'m doing yet.