MTU.Community (
-   MicroCD Help (
-   -   Write command failed. (

Hessel September 25th, 2001 01:19 PM

Write command failed.
What means that message?

"Write command failed on device 0:3:0 . Hardware error 00h 02h 04h 09h

I have been used microCD2.3 without problems but now i have this message after some time of burnning at my 4260 Yamaha recorder.


MTUSUPPORT September 26th, 2001 04:59 PM

This error means that something has happened to the hardware. Since this drive is a SCSI drive it could be your SCSI cable, or Card or the CD-R drive giving you problems. You could try to update the SCSI drivers and see if this will help, or try to clean out the CD-R drive with a can of Compressed air (available from most computer stores. If this is not the case, the drive may have died on you.

All times are GMT -4. The time now is 09:49 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2021, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.