microstudio latest version

[finjim]

microstudio will not see my writers
when trying to open getting error message which say - error reading inquiery data for device,s error=1 this comes up with prefixed numbers 5 and 35
i am running windows xp pro with sp2
have already tried aspi updates does not work

[George]

What brand and model drives are you using?

What happens when you click on DETECT DRIVES?

George

[MTUSUPPORT]

Update your Motherboard drivers. This error says that your computer does not like our ASPI driver. So you may need to search for wnaspint.dll and delete this file from C:\Windows\System32, it should then open, rather the drives show or not, this will depend on the Adaptec ASPI or some other ASPI drivers, sinc this system will not allow ours to work.

[finjim]

am using pioneer dvr 109
and lg hl-dt-st dvdram gsa 4163b
have already followed mtu instruction regarding aspi with no effect
when i click detect drives box opens to show detected drives but nothing shows
have already updated motherboard with no change still same when trying to open microstudio

[MTUSUPPORT]

Neither of these drives support the CD+G format, but this problem should still not occur, but on some systems. Even if the software was working, those drives can't copy or do anything with CD+G. The only brand of drives tha work are Plextor and here is a List: http://www.mtu.com/support/faq/faq-m...#PlextorDrives

[finjim]

have already used these drives with previuo version of microstudio
on same system i am on now but with 98se installed
and these read and wrote cd+g

[MTUSUPPORT]

They might work under 98se, but that is not the same at all as if they will work under XP, you might have to get some updated firmware for the drives to make them work.

As far as I know these drives should not work.

[finjim]

thanks for your help i will get me a plextor writer for now hope this works
i have read you are releasing a version 3 of microstudio that will work with a lot more drives i will wait for this and try that out
again thankyou for your response . finjim

[MTUSUPPORT]

I am not sure when the Microstudio 3.0 will be finished, the codes are still being written and tested in Hoster. Then, they will start on Microstudio, which should take a while I have been told, as there is alot more to integrate it into Microstudio than Hoster.