|
Microstudio Help Post Microstudio questions, tips and suggestions here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Graphics mess up after trk 9
Help I am trying to back up single tracks from several cdg using microstudio 2.311. When I burn the tracks from my hard drive starting with track 10 the graphics get progresivly worse till you cant even read them. I have tried many diffrent tracks in diffrent orders it dosn't matter I all ways have the same result.
System config: MII 300mhz 64 meg ram plextor 12/10/32a note: when i play the tracks from the hard drive they are fine. please help I have enough cd coasters now to supply a small army. thanks Kevin |
#2
|
|||
|
|||
Kevin,
This normally occurs when you have a bad drive or bad media. Did you buy the CD-R from MTU? If so then most likely the drive is fine, if you didn't then you could have a bad drive. If you are using cheap media then this can cause the problems. I would only recommend using Mitsui or Sony Media. This should take care of the problem, and most likely it sounds as if it is a media problem to me, since it seems to read in a clean copy of the song to the hard drive, but it having a problem once it has written it to the Disc. Let me know if this is the problem.
__________________
Bryan, MTU |
#3
|
|||
|
|||
I did purchase the drive from mtu but the media is cheap.
I thought that was the problem just needed someone to tell me. thanks |
#4
|
|||
|
|||
I would only use the Mitsui media or Sony. This should fix your problem.
__________________
Bryan, MTU |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|