Page fault when starting Microstudio 2.103 - Needed to upgrade ASPI Driver

[derick1]

I'm having trouble anytime I start Microstudio v2.103. As soon as I start it I get a page fault with the following error:
MICROSTUDIO caused an invalid page fault in
module at 0000:760e1494.
Registers:
EAX=ffffffff CS=0167 EIP=760e1494 EFLGS=00010286
EBX=00000000 SS=016f ESP=00b0ff90 EBP=00b0ffcc
ECX=c16dc550 DS=016f ESI=bff92c37 FS=2d17
EDX=bffc9490 ES=016f EDI=bff7c8bd GS=0000
Bytes at CS:EIP:

Stack dump:
81739a7c 00000008 81736524 bff88f20 760e3158 81739a7c 00000008 81736524 00000007 00b0ffa4 00b0fdc0 ffffffff bffc05b4 bff79050 00000000 00b0ffec

When I close out the error, the program shuts down. I've tried rebooting, reinstalling, and even fdisked the drive twice and reinstalled everything. No luck. I've made all the settings per mtu install information, the only thing I could not find was the aspienum.vxd file. I've tried checking for ASPIENUM.VXD, but could not find it at all on my computer. I've emailed mtu, but I just wanted to check here in case that isn't the cause since I'm wanting it working for this Saturday.
My machine has the following:
amd400, fic motherboard VA-503+,128 mb of toshiba ram, a 20 gb hard drive, a generic 4 mb S3 agp card, and audiophile 2496 audio card for sound(I've also tried a generic sound card with opti 931 chipset.), a network card, and a modem. I'm using the plextor 12x/10x/32A that I bought from mtu. I use the plextor software no problem. Burning discs is no problem (obviously, I don't know about cdg's...). To repeat, I cannot get microstudio to work at all, and I was hoping to use it this weekend for my birthday party to play some cdg's I was going to rent. I've no problems running cakewalk 9, chordfinder, or raygun. (So far the only programs on the machine.)
Thanks in advance, David.

[Edited by derick1 on 02-18-2001 at 08:38 PM]