The JVC karaoke player can't read my burned CD's

[psmau]

When I burned a song I made, the JVC Karaoke player didn't recognize the disk or track.

When I played a song I made in the Producer with Producer, it looked fine... but on MicroStudio when I select "play" it was a mess. The texted ran all over and the characters were partial and spotted.

When I imported a cdg from a purchased karaoke CD and burned it, the Karaoke player also did not detect it ... again, "no disc"

My system:

Motherboard Soyo K7VTA-B
CPU AMD Athlon 900Mhz
CPU Cooling Thermaltake Volcano II
Memory 256MB PC133 SDRAM
Video Card Nvidia Vanta 16MB AGP
Sound Card Onboard AC '97 Audio
Modem Creative Labs ModemBlaster 56k PCI
Network Card Realtek chipset 10/100 NIC card
Hard Drive Maxtor Diamondmax 60+ 20GB
Samsung 52X IDE
Floppy Drive Teac 1.44MB
Operating System Windows 98SE Plus!
with the plextor 12x10x32 IDE

[MTUSUPPORT]

On some of the JVC players you might have to record at 1x speed for them to read the disc as a CD. You might also have to use quality media instead of the cheaper media. I would use either Mitsui media which you can purchase from Master Recording Supply in CA, 800-860-4560, or try the Sony media that you can find in most stores.

Try reading some of these posts about the JVC players that have already been found as being difficult. ttp://www.mtu.com/vbulletin/showthread.php?threadid=490&highlight=JVC%2A
http://www.mtu.com/vbulletin/showthr...ghlight=JVC%2A
http://www.mtu.com/vbulletin/showthr...ghlight=JVC%2A
http://www.mtu.com/vbulletin/showthr...ghlight=JVC%2A
http://www.mtu.com/vbulletin/showthr...ghlight=JVC%2A

I hope that some of this information will help you. We don't have any personal experience the with the JVC players as most of these clients do have them.