|
|
|||||||
| KPro Studio and KHPro Help Post KPro Studio and KHPro questions, tips and suggestions here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
February 15th, 2003, 08:35 PM
|
|||
|
|||
|
Help
I just downloaded the upgrade from Khpro 3.1 to Kpro4 including the macid. I have the network usb plug I ordered from you guys when I installed Hoster. It is identified in the system and working properly, however, when I attempt to run the ID nothing is found. I tried the suggested trick of writing to floppy which will not work either.
Can I send the ID that was generated with Hoster? And, are there any special instructions if I can? 
|
|
#2
February 15th, 2003, 11:15 PM
|
|||
|
|||
|
Windows version?
What Windows (98, 98SE, ME, etc.) are you running?
|
|
#3
February 16th, 2003, 02:58 PM
|
|||
|
|||
|
Windows XP. On a Hp P2, 300mhz. This is not the computer that I downloaded Hoster on, however I did download the last Khpro 3.1 onto this one. The network plugin is identified and operating but of course it states that the interconnecting plug is disconnected, since there is no other computer hooked in.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
