|
|
|||||||
| KPro Studio and KHPro Help Post KPro Studio and KHPro questions, tips and suggestions here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
March 1st, 2003, 01:50 PM
|
|||
|
|||
what speed to burn at
this question is for mtu
i have the plextor 48 24 48 what speed is the best for making the masterdisks? i am running windows98se with an athalon processor. you say you test all drives so i just want to know the best speed settings that you suggest. your input would save me from trial and error. thank you farmertom 
|
|
#2
March 1st, 2003, 02:42 PM
|
|||
|
|||
|
Farmerton,
It's better to run it automatically!  Open MicroStudio Click on Drives Click on Speed Selection Choose Auto Select for both Reading Drive and Writing Drive Click Ok.. ….and you are set.  Good luck, Jon
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
