MTU.Community


Go Back   MTU.Community > Microstudio Software & Burners > Microstudio Help

Microstudio Help Post Microstudio questions, tips and suggestions here.

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #31  
Old June 30th, 2006, 01:21 AM
ddouglass ddouglass is offline
Super Moderator
 
Join Date: Nov 2004
Location: Ace, TX (5 miles past Nowhere)
Posts: 9,395
Gary, I think that Dell is right that the drive is bad. Have you ever had a floppy disk that the drive it was written on could read but no other floppy drive could read it? This is caused by misalignment of the drive head.

In a cd drive instead of a magnet head you have a laser and an photo-diode. the laser emits the light of course and the photo-diode reads the light reflected off the disk. The speed of the read function (48x, 52x, etc) determines the timing for the laser/photo-diode operation. If this timing is off due to a failure or change in component values then the drive may read at some speeds but not at others. I know this sounds complicated but this type of problem does point to a hardware problem and not a software one.
__________________
Dale Douglass
2nd Generation Karaoke
I am not a member of the MTU Staff.
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


All times are GMT -4. The time now is 03:01 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2024, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.