|
|
|||||||
| MicroCD Help General forum for discussing MicroCD and audio CD mastering. |
 |
|
|
Thread Tools | Display Modes |
|
#1
September 25th, 2001, 02:19 PM
|
|||
|
|||
Write command failed.
What means that message?
"Write command failed on device 0:3:0 . Hardware error 00h 02h 04h 09h 00h." I have been used microCD2.3 without problems but now i have this message after some time of burnning at my 4260 Yamaha recorder. Hessel Last edited by Hessel; September 26th, 2001 at 04:10 PM. 
|
|
#2
September 26th, 2001, 05:59 PM
|
|||
|
|||
|
This error means that something has happened to the hardware. Since this drive is a SCSI drive it could be your SCSI cable, or Card or the CD-R drive giving you problems. You could try to update the SCSI drivers and see if this will help, or try to clean out the CD-R drive with a can of Compressed air (available from most computer stores. If this is not the case, the drive may have died on you.
__________________
Bryan, MTU
|
|
| Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
|
|
Linear Mode
