|
|
|||||||
| Microstudio Help Post Microstudio questions, tips and suggestions here. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 4th, 2009, 07:28 AM
|
|||
|
|||
|
"That may be what is also wrong with the initial burns in Microstudio then. For some reason the drive or Vista is not finalizing correctly."
This is the very conclusion that I can come to, me and another actual computer person have been doing some testing and changing some things that may have an impact and then trying to burn again...so far, all fails. Try finding some updates for these slimline drives....what a chore. I've updated everything else that I can find. I will keep trying, hopefully find a solution here in the future. Thanks, Larry 
|
|
#2
June 4th, 2009, 09:32 AM
|
|||
|
|||
|
Should be driver and maybe even firmware updates for it in HP Support.
Do you have the UAC turned on or off on this laptop? It could be that Vista is not giving any programs full control over the drive, though I would suspect the drive itself (driver, firmware or hardware) more than I would Vista in this case.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
|
#3
June 4th, 2009, 09:39 AM
|
|||
|
|||
|
UAC is Off, I am the only user, with admin rights. It's appearing to be some sort of permissions issue. Not sure what though, will keep trying!
Thanks, Larry
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
