CMOS Issue

[jaddams]

Originally posted by MTUSupport
He was telling me something about he was able to set both monitors to the Primary Monitors for both. I believe that this has messed up the video driver somehow.

This is why when the driver loads, the monitors both go black. I am not sure why it won't allow him to go into Safe mode, without the Video going out also.

This doesn’t make too much sense to me. Safe Mode boots using standard VGA drivers built into Windows. If he cannot boot in safe mode, the problems lies somewhere else, not on the video drivers. I still suspect improper setting on CMOS, as it can be confusing to set up CMOS using a RAID 1 configuration after disabling it, accidentally or not.

Best regards,

Jon