![]() |
|
#1
|
|||
|
|||
Re: Fast sweep
It is just about right with +1
|
#2
|
|||
|
|||
Re: Fast sweep
When you had it set to -.3 had you changed the DirectX settings for Hardware acceleration? If so you may need to change them back and then reset Hoster.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
#3
|
|||
|
|||
Re: Fast sweep
As far as I know I did not mess with the directx settings. How do I do that?
|
#4
|
|||
|
|||
Re: Fast sweep
DXdiag - type that in the Start Menu/Run and that will open the DirectX Diagnostics.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
#5
|
|||
|
|||
Re: Fast sweep
I did entered DXdiag and got the dialog box but everything seemed to be ok with no problems noted. How would I reset it? All Accelerations are enabled and I don't see any way to change them
|
#6
|
|||
|
|||
Re: Fast sweep
In DXDiag there should be a tab at the top for each sound card. On those pages is a Hardware Acceleration. Try lowering it from the top (max) acceleration level, down one notch, restart the computer and see if it isn't closer on the sync.
Also with these later versions you need to be using the latest DirectX and Windows Media Player. Make sure you have them updated too.
__________________
Dale Douglass 2nd Generation Karaoke I am not a member of the MTU Staff.
|
#7
|
|||
|
|||
Re: Fast sweep
Dale, all I have at the top of the box is
System, Display, sound 1, sound 2, sound 3 and input none of these tabs have any way to adjust anything. No way to adjust anything in the DXdiag as far as I can see. I am using Windows 7 64 bit |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|