CMOS Issue

[jaddams]

Thank you Ashton,

Part of your link worked. Here is the correct link ftp://ftp.shuttle.com/Manuals/en/fn41/fn41en.zip

Thanks again

Jon

[jaddams]

Originally posted by MTUSupport
He was telling me something about he was able to set both monitors to the Primary Monitors for both. I believe that this has messed up the video driver somehow.

This is why when the driver loads, the monitors both go black. I am not sure why it won't allow him to go into Safe mode, without the Video going out also.

This doesn’t make too much sense to me. Safe Mode boots using standard VGA drivers built into Windows. If he cannot boot in safe mode, the problems lies somewhere else, not on the video drivers. I still suspect improper setting on CMOS, as it can be confusing to set up CMOS using a RAID 1 configuration after disabling it, accidentally or not.

Best regards,

Jon

[smlaemm]

Thank you all for support on this. After talking with Bryan today, I think the best thing to do is send the computer to him. Will look forward to the results!

Scott

[jaddams]

Good move Scott. Bryan and the rest of the crew at MTU will fix it.

Regards,

Jon