[mlepine]

I remember having a similar problem with my graphic in the past on both Micro & CDRWIN so when I disabled my DMA on both my hard drive & CDR-RW (for playback) it solve my problem.

Do you know how to disable it?
Click start, contol panel, system, hardware, device manager, IDE ATA/ ATAPI controler, primary IDE chanel, advance settings & put all Transfer Mode to PIO only. Repeat for the secondary IDE channel. Make sure to have both device 0 & 1 identical.

This was the only way for me to get a good graphic with my Yamaha burner and using both software mention below.

Good Luck!

PS- IF you see no changes I recommend you go enable your DMA's & don't worry this will not cause any damage to your system.