|
OKay.. I'm getting frustrated now..
Okay... Got the memory in(192k)... downloaded 2 new drivers from Compaq, have all the correct ASPI drivers, reconfirmed all the drive settings.... And after $350.00 spent plus my time I'm still burning coasters...
Here's whats happening... reads the cdg just fine loading it to drive D... Then when I swap in the new cdr and start the burn it goes fine until the same place everytime... It locks up at track 8 65% (and I've tried other cdg's)... So it quits and I hit terminate...Then I get an error from Microstudio that reads Microstudio busy please try again. and the system locks up... I have tried every trick so far... even de-installed my old adaptec direct CD, I have all the updated drivers, I'm starting to think it's the Microstudio software... I am getting very frustrated at this point. Am I missing something????
|