Well, medit has been fine for years but they haven't used the msync. I got hold of Bryan and checked the IRQs and sure enough both xtal and msync were on IRQ 11. I put Msync on IRQ 5 and totally uninstalled Medit,Mchange, and MicroCD and tried reinstalling and it came up saying that it could not find the Msync board or it was in use by another application. OK, so I put it back on 11 and reinstalled everything and it still gives me that same error. Next I took the cable apart and resoldered the wires (one by one) and tried again. Still it won't see the Msync board. About the only thing I've got left is to go into BIOS and switch the PnP on IRQ 5 to Legasy ISA and hope for the best. Our other 5 MTUs are in use so I can't get a look at those (you have to take it apart since the Msync board won't show up in device Mgr so you have to look at the jumper setting) but all act differently. Some work fine but device mgr says "other devices" not working properly or needs the drivers updated. Some have a yellow "!" on them and some are just listed as "other devices" no driver present nor needed. It would be nice if I could have all of them looking the same.
|