Something to be said for the word: "Convenience"
A final note concerning my heavily modified
"antique" TEAC TASCAM MODEL 5:
Socketed IC's are a wonderful thing.
(As long as you use the gold plated ones
to ensure optimum contact.)
Having looked over many of the newer mixing
boards at various audio retailers... I see
a maintenance issue I don't have with my
old module based Model 5:
the larger scale circuit boards used currently
make repairs a major ordeal.
When I have a problem, I have two choices:
a) Remove two skrews, pop the front panel, remove one *****
I meant skrew, *geesh Dave*
and PULL the channel module, pop in a few new op-amps,
and re-install. The process takes less than 15 minutes.
b) Change out a module... but how could I improve on (a) ?
I stock at least 50 spares of each chip type thanks to Ebay.
A while ago, I bought a 3rd Model 5 board as a spare
and for remote use. So, I've always got SOMETHING
to get through the moment.
If I had a newer mixing board... repairs would THEN mean...
UNPLUGGING THE ENTIRE CHASSIS and unscrewing a
major portion of the casing, just to replace an op-amp!
And in my case, where I've harnessed the entire board's rear
I/O's to the PATCH BAY, it just looks like a newer mixer would be
the more trouble than it's worth!
RE: screws, ***** or skrew...
(Pitty to the forum if Dave or "the web meister" get their
hands on a Thesarus of Rap and Heavy Metal words!!!!)
__________________
G. Boggess
Last edited by Gary Boggess; October 22nd, 2007 at 10:24 AM.
|