luigi77047, actually from our experience, HP drives have a 40%-60% chance of not working correctly with CDG. However, your problem does not seem to be this type of failure. I expect your video card is doing something that doubles your display lines. This is not seem to be a Microeditor software problem, but rather a system integration problem... the toughest type to troubleshoot as every one is different!
Thanks GordonF for your excellent points to review. Luigi, read my post at
http://mtu.com/vbulletin/showthread.php?threadid=151 "Problems and Solutions" and make sure you have eliminated all of them. These are for V2.013, but most also apply to 2.103. GordonF's point about the ATA driver could very well be the answer to your problem.
Try this also. Make sure your CD-Recorder is a master device on the IDE controller it is attached to. Check with eMachine as to how to do this if it is not in your manual. Don't have the CDR on the same IDE controller (use the other IDE ribbon cable connector at the controller) with your hard drive. This may cause problems.