[Altair]

1) I have just purchased Microstudio 2.315 and am finding a few problems with it, at the bottom of the page I have pasted a couple of the error messages I am receiving.
The first problem is that on occasion, when writing a disk to the Hard Drive I get an error message and I can't close the message window, the only way I can get out of it its to reboot. The biggest problem is when I try to make a second copy of the CD+G or if I say no to the second copy and try to copy another disk. I consistently get the error message with the same results (reboot to get out). I have made many coasters trying variations of copying, but the only way I seem to be able to copy another disk after one has been successfully copied is to shut down the computer and start it back up. Even if I close the program, start it back up and try to copy a second disk it will then lock me up.

Illegal Operation

MICROSTUDIO2315 caused an invalid page fault in
module KERNEL32.DLL at 0177:bff88396.
Registers:
EAX=c00309c4 CS=0177 EIP=bff88396 EFLGS=00010212
EBX=006dffec SS=017f ESP=005dfe98 EBP=005e0010
ECX=00000000 DS=017f ESI=00000000 FS=1a27
EDX=bff76855 ES=017f EDI=bff79060 GS=0000
Bytes at CS:EIP:
53 56 57 8b 75 10 8b 38 33 db 85 f6 75 2d 8d b5
Stack dump:

MICROSTUDIO2315 caused an invalid page fault in
module KERNEL32.DLL at 0177:bff7d76b.
Registers:
EAX=fed84000 CS=0177 EIP=bff7d76b EFLGS=00210217
EBX=81d6512c SS=017f ESP=01a5fb90 EBP=01a5fbbc
ECX=84e65ea8 DS=017f ESI=00008c85 FS=0d1f
EDX=bffc9490 ES=017f EDI=fed3dbd0 GS=0000
Bytes at CS:EIP:
83 38 00 74 28 83 c0 08 46 3b f1 72 f3 be ff ff
Stack dump:
01a5fbbc bff7c8bd 01831200 00000000 bff92e7f 81d6512c bff89b1a 81d6512c bff7c8bd 00801860 00801860 01a5fbe4 bff92b47 00000000 00000000 01831200

2) When I try to play a CD+G on my computer (that I have just copied) using your program, it skips and repeats etc. If I play it on my Karaoke machine it plays fine.

3) If I use the button "Check MTU Site", does that count as one of my 8 downloads?

4) Do I need to download the ASPI Drivers For Windows 95/98/ME/2000/XP that are mentioned in the forum by Bryan Cox, MTU? I have used other copy programs quite successfully, Adaptec Easy Cd Creator (older Versions 2 of), Roxio (new)

5) What are the fastest speeds I should be using to copy CD+G's with Microstudio 2.315, right now I have it set on Automatic and I don't think that is my problem because it will make the first CD+G alright, it's just when I try to copy a second disk or make a second copy that I run into problems.

My system is:
Pentium III 450
Win 98 second edition
512meg ram
Hard drive speed 7200 rpm
Burner - Plexwriter 40/12/40/a