MTU DISC COPY INSTRUCTIONS
(After hardware installation)
1. Power on computer
2. Power on CD+G Drive
3. Place CD to be copied in tray
4. Cancel pop-up, click Microstudio icon on desktop
5. Click “Import Tracks”
6. Make sure CD + G drive is selected
7. Enter a disk ID where prompted (usually an identifier of source CD)*
8. Click “Read Disk”
9. Click as many tracks as you wish to copy (hold down Control key to select multiple)
10. Click “Import Selected Tracks” and wait for them to be imported
11. Click “Close” and remove source CD
12. Right Click on each new song, hit “rename,” and insert song name*
* NOTE: Use no punctuation marks throughout!!!!
13. Drag songs to Play List on right hand side of screen
14. Select songs to be copied on blank CD by holding Control key
15. Load blank CD and click “Add to Write List – a bell sound will occur
16. Click “Write Disk” on top masthead
17. Select proper disk length in minutes and make sure two minute gap is on
18. Click “Write CD” and wait for completion
NOTE: Highlight all songs and click “Delete” on Write Disk screen