[flipper]

I have Hoster 3.303 and have been having no problems whatsoever.

Just the other day I burned a custom assembly disc from cdg files on my external hard drive with Microstudio 2.609 then added them to hoster by importing them from the disc. I did this with a PX4012 plextor MTU Certified Drive.

Before I imported the files I checked them by playing them in Microstudio to make sure they were good files. Then imported them in hoster.

When I played the files in hoster after import there was a rapid clicking sound with no graphics just a blank screen.

I have been doing this exact method for quite some time with no problems whatsoever. I imported discs just last week with no problems at all.

I considered a possible media problem but I'm using the same discs as before, and if it was bad media it would show up when I check the disc in microstudio.

Any ideas?