Quote:
|
Originally Posted by ddouglass
I'm sorry George...I knew that but had a senior moment. 
I think their reasoning was to eliminate the confusion factor for those who are less computer literate. There was a lot of problems with people not setting it correctly when the previous version was released.
I don't think being able to turn it on will make your import any cleaner for the plextors. |
I see! I would not want to turn it on as my experience is that my imports are better with it off (hardware decoding). You are saying that you believe that Software decoding is turned off automatically if you are using a MTU approved drive. Therefore if software decoding is turned off, you are using hardware decoding. That might be so, but my experience was with the prior version, with software decoding turned off that my imports were good and fast. Now with the new version software decoding is turned off as I am using a MTU approved drive but my imports are not as good and much slower. I can live with it if I have too. In your opinion, what types of things would help? These are brand new disks. I read in the Troubleshooting section of Hosters help menu that a lot of Chartbuster disks are warped and that is the reason you must slow down the read speed of the drive. Are any other manufacturers disks better? I have not seen their recommendations but I am assuming they would not recommend one over the other. It is possible that the three disks I just imported are worse than others and I have not imported them on my backup system yet(716-A drive) so it is possible that this is more of a drive issue. I am going to import them into my backup system and see. I will post what I find.
Thanks
gpayne