[MTUSUPPORT]

Most likely it has turned off the DMA on the IDE controllers.

You can fix this by doing the following:

1) Right Click on the My Computer Icon. Left Click Properties.

2) FOR XP or 2000 Users: Left click the Hardware Tab then Left click the Device Manager button.
FOR 98SE or ME Users: Click the Device Manager Tab

3) Left click the + beside IDE ATA/ATAPI controllers

4) Double click on Primary IDE Channel. Left click on the Advanced Tab. Make sure that both Device 0 and Device 1 have the Transfer Mode set to DMA if available. It this is set to PIO Only, then it can cause this error.

5) Now do the same as above, but for the Secondary controller as follows. Double click on Secondary IDE Channel. Left click on the Advanced Tab. Make sure that both Device 0 and Device 1 have the Transfer Mode set to DMA if available. It this is set to PIO Only, then it can cause this error.

6) Reboot your computer and make sure these settings correctly changed.

If this is now correct, try burning a disc again in Microstudio and see what happens.