|
Tymzend,
The system was tested and working. Have you installed any other programs or hardware?
I see that you have installed this piece of Hardware:
Name: D-Link AirPlus DWL-G520 Wireless PCI Adapter(rev.B)
Device ID: PCI\VEN_168C&DEV_0013&SUBSYS_3A131186&REV_01\3&61AAA01&0&40
Driver: C:\WINDOWS\System32\DRIVERS\A3AB.sys, 3.00.0000.0441 (English), 3/12/2004 20:38:54, 344928 bytes
Driver: C:\WINDOWS\System32\DWLInst.dll, 1.00.0001.21216 (English), 1/27/2003 17:29:54, 24576 bytes
It should be fine, but I don't know. I have never tested this.
Also, I compared your Dxdiag to a new system that is identical to yours, that I am building. You have turned off your DirectDraw. This could cause your problems. Please turn this back on, by doing the following:
1) Click the start Menu. Run. Type in Dxdiag. Click on the Display Tab.
2) Make sure that the 3 buttons at the bottom of this show Disable. If they show Disable, then it menas that they are Enabled. If the buttons show Enable, then the item is Disabled.
Click Exit.
Let me know what happens when you do this.
__________________
Bryan, MTU
|