When you receive this error message it means that there has been a buffer underun. Thus meaning that the data is not being sent from your Hard drive to your CD-R drive fast enough.
Make sure that you have turned on "DMA" on your CD-R drive.
http://www.mtu.com/support/microstud...tall-sheet.htm is the installation checklist that will tell you how to turn on "DMA" and all other changes that should be made.
The problem can also be caused by recording too fast for your computer. To slow down the reading and/or writing speeds for the CDR drive:
Run Microstudio 2.311
Click the Drive menu
Click the Speed Settings command
Click Auto Select off
Select a slower speed
Suggestions: To write faster than 6x-8x your hard drive needs to rotate at 7,200RPM ( Most 40GB and larger drives rotate at 7,200rpm). We test our 16x CDR drives on a lowly Pentium 166MHz with a 9GB 7,200RPM IDE drive with DMA enabled. We never have a problem.