Kerrie,
First you should upgrade you DirectX, providing your graphics card support it, to the latest version which is 9.0b, from the
Microsoft Website
Then, why would you want to read and write at 1x when you have a very good Plextor (52-24-52) which is capable to write a whole “very high quality” CDG in less than 6 minutes?
However, if you insist, where is how you can choose your speed?
1. Open MicroStudio
2. Click on
Drives
3. Choose
Speed Selection
4. For
Writing Drive uncheck the box if selected.
5. Choose your desired writing speed (1x?)
6. Click
Ok
Try it now. It’ll write at 1x and it’ll also take a very long time.
Now rewrite the same disk at 52x and check the quality on both. You probably couldn’t tell the difference.
Now, isn’t better to write at the higher speed?
Enjoy.
Jon