Rev-J and 2.6 and 2.7b--how to get running
 

I recently put my Rev-J board and Synch board into a newer used Pentium3 with 3 ISA Slots, I then installed Windows 98, Next I installed the 2.6 and 2.7b software, now I get "can't access Microsound Device" when I try to open either...

I used the defaults for the IRQ and memory settings when I installed...

Also I ran the MSNDSTAT.exe and got the following---

Microsound DSP56001 #1
Device status : FUNCTIONING
Aplication status : AVAILABLE
DSP State : RESET
Memory: NOT ENABLED
Interupt: NOT ENABLED
Bus Mastering: NOT AVAILABLE
Current Error Code = 0
HICR = $08, HISR = $0E

It looks like a memory address problem - but what are the steps to fix?

Can any engineers at MTU help with this, can you E-mail me any info or instructions?

I tried your link--- FOLLOW THESE STEPS if installing 2.7 to run with a Microsound AT-DSP56 Rev-J board or you will see Unable to access Microsound device and Microeditor will terminate.

But the link is dead...

Wrong Forum?
 

Don't know how to alert the moderator, but I think this thread needs to be moved??