Failed Microstudio 2.604 Upgrade
 

Yersterday I tried to get the free upgrade from 2.517 to 2.604.

From the Microstudio Overview page:-

"Version 2.604 is a free upgrade for all Microstudio 2.506 and higher owners by clicking your download link in your email with your Registration Code. "

I have done this, and I have run the file. I have tried both the modify and repair options but the software still shows as version 2.517 and does not have the changes listed in the Version Upgrades page.

I did not overwrite the original download file, but this and the new download are exactly the same size 3003Kb (I expected the file to have the same name - this has been the case in previous software upgrades from MTU). This makes me think the new file has not been downloaded.

Have I done something wrong? Have I mis-read the installation software that says use modify or repair to upgrade? Have MTU failed to make the new download file available?

Jim

Sorry, I updated the web site too fast...
 

Jim, you did nothing wrong. It was my fault. :s

The new microstudio2604setup.exe file was not built until yesterday morning. Since it takes hours to modify the web site for a new upgrade (especially Microstudio), I did that in the wee hours of the morning. :r

I didn't upgrade our home page until I got to work and the new .exe was built and uploaded to the web site. However, you were too good!!! You saw the upgrade was "announced" and downloaded. :c

Click your download link again and you will now get 2.604 delivered to you. :)

Sorted!

Thanks

Jim

PS. Installation dialogs referred to Hoster installation but I ignored that.

Always on top
 

Dave (MTU president) will always take care of MTU's customers.

Sincerely,

jon