"No" for karaoke on Plextor
 

Have installed Microstudio and now Plextor CD-R. Finally got Microstudio to recognize Plextor but now when I pull up "drives found" it shows a "no" under "karaoke" hence I can't use the Plextor drive to read or write. Can someone help me solve this problem?

What Plextor drive do you have? Also, what version of Microstudio?

Microstudio 2.400 supports up to the Plextor 48x drive. If you have the new Plextor DVD burner it is not yet supported.

If you have Microstudio and the Plextor drive both that are supported, then it could be your ASPI drivers. You can reinstall these from: http://forum.mtu.com/showthread.php?threadid=493

If this still doesn't work, then reinstall Microstudio.

Hi Bryan,
I have Microstudio 2.315 and Plextor CD-R PX-W4824A 1.03. Are these compatable?
Thanks,
Jim

sheltraw,

Your Plextor CD-R PX-W4824A IS NOT supported in MicroStudio 2.315. You will need to upgrade to MicroStudio 2.4 to be able to use that burner.

http://www.mtu.com/store/merchant.mv...gory_Code=C001

Good luck,

Jon

I just purchased a px-w 4824tu from you. Wy microstudio says no for karaoke. Do I need to upgrade. I have aV2.315. Thanks

No Karaoke
 

Also you stste above about a 2.0 and your link says 2.4 are they the same

Jester,

You need to upgrade to MicroStudio 2.4 to use your CD-R PX-W4824A. Version V2.315, DO NOT support that drive.

Thanks for the tip. You're right my earlier post was meant to say 2.4 and not 2.0

Here is the link for the update page.

http://www.mtu.com/store/merchant.mv...gory_Code=C001

Good luck,

Jon

Just want to say thanks for the help. Downloaded 2.4 this morning and I'm "up and running. :) Lookin forward to lots of fun and convenience with my new capabilities.
Jim Sheltraw