MTU.Community

MTU.Community (http://forum.mtu.com/index.php)
-   KPro Studio and KHPro Help (http://forum.mtu.com/forumdisplay.php?f=75)
-   -   Network Adapter (http://forum.mtu.com/showthread.php?t=2471)

gizmo June 29th, 2003 06:31 PM

Network Adapter
 
the drop down box is asking me to select a Network Adapter Mac ID. But in the display it shows none found. It will not allow me to select any box.....HELP

Flipeoke June 29th, 2003 10:32 PM

Do you have a network card installed in your computer, if not an inexpensive solution may be found here.

If you do already have an ethernet/network card in your computer check to see if it is working properly.

Here's an answer from another post:

Quote:

Originally posted by MTUSUPPORT
Do you have the drivers for this card installed? Is the card enabled?

You can check this by going to your My computer Icon (on the desktop) RIGHT click on it, Left Click on Properties. Once this opens, click on the Hardware Tab, then Click on the middle button stating Device Manager. This will then open. You should see a Section that states Network Adapters. Make sure that your Network card is showing under this and that it states that it is working correctly.

If it has a Yellow ! on it, or a Red mark, it may not be correctly installed. I would then uninstall it and then reinstall it and then try the program again.

Flip

gizmo June 30th, 2003 10:42 PM

I have tried the above and it says it is working properlybut it will not let me select anything

stritti July 1st, 2003 01:44 AM

Same problem as I have (reported in thread http://forum.mtu.com/showthread.php?s=&threadid=2435 ) so I cannot install te program I have bought. Wolfgang from Germany


All times are GMT -4. The time now is 01:12 PM.

Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2024, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.