MTU.Community

MTU.Community (http://forum.mtu.com/index.php)
-   Microstudio Help (http://forum.mtu.com/forumdisplay.php?f=6)
-   -   Microstudio does not detect any drives (http://forum.mtu.com/showthread.php?t=1368)

poptime August 31st, 2002 01:08 AM
Microstudio does not detect any drives
 
Help! Microstudio seems to run ok, but does not detect my plextor 24/10/40A (from MTS) or the other cdrw, either with Karaoke or with audio buttons. Also, Plextors DiscDope will make an image to hard drive, but will not write it to blank cd. I have gotten the Roxio program to make data cd. I have DX version 8.1 320M ram, no problems listed under diagnose. I have tried uninstalling everything and reinstall, disconnecting drives (both and either) and removing from device manager and reinstalling, nada.
Any ideas???
Thanks,
Dwight

George August 31st, 2002 11:16 AM
Dwight,

See the post at beginning of this forum by Support regarding ASPI drivers and instructions on downloading. Perhaps that may be the problem. Hope so.

Take care,

George

poptime September 2nd, 2002 10:08 PM
George, good call, thanks. That does seem to help with MicoStudio. It was set on using MTU aspi drivers and I changed to default, presto the drives showed up.
Dwight


All times are GMT -4. The time now is 06:48 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2009 - 2024, Jelsoft Enterprises Ltd.
The contents of this forum are copyrighted by Micro Technology Unlimited, 2000-2008. Use of any material from these Forums is prohibited without written agreement from MTU.