PDA

View Full Version : Graphics mess up after trk 9


probowler
October 24th, 2001, 03:13 PM
Help I am trying to back up single tracks from several cdg using microstudio 2.311. When I burn the tracks from my hard drive starting with track 10 the graphics get progresivly worse till you cant even read them. I have tried many diffrent tracks in diffrent orders it dosn't matter I all ways have the same result.

System config:
MII 300mhz
64 meg ram
plextor 12/10/32a

note: when i play the tracks from the hard drive they are fine.

please help I have enough cd coasters now to supply a small army.

thanks Kevin

MTUSUPPORT
October 24th, 2001, 03:27 PM
Kevin,
This normally occurs when you have a bad drive or bad media. Did you buy the CD-R from MTU? If so then most likely the drive is fine, if you didn't then you could have a bad drive. If you are using cheap media then this can cause the problems. I would only recommend using Mitsui or Sony Media. This should take care of the problem, and most likely it sounds as if it is a media problem to me, since it seems to read in a clean copy of the song to the hard drive, but it having a problem once it has written it to the Disc.

Let me know if this is the problem.

probowler
October 24th, 2001, 03:41 PM
I did purchase the drive from mtu but the media is cheap.

I thought that was the problem just needed someone to tell me.

thanks

MTUSUPPORT
November 5th, 2001, 01:51 PM
I would only use the Mitsui media or Sony. This should fix your problem.